Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
top right (5) motif encoder doesnt work
#1
Hello everyone,

I was hoping to get some help. My top motif encoder doesn't seem to work. POSITION/PATT-LEN, pattern editor and LFO CONFIG does not respond. The arrow changes (up/down) when I press the encoder down but turning turning the encoder left to right and right to left have no effect. Am I missing something? Everything else seems to work fine. 

firmware 1.1.073
SN 0110382190
Reply
#2
(02-24-2021, 05:50 PM)calvin Wrote: Hello everyone,

I was hoping to get some help. My top motif encoder doesn't seem to work. POSITION/PATT-LEN, pattern editor and LFO CONFIG does not respond. The arrow changes (up/down) when I press the encoder down but turning turning the encoder left to right and right to left have no effect. Am I missing something? Everything else seems to work fine. 

firmware 1.1.073
SN 0110382190
Hey Calvin,
Sorry to hear you're dealing with a dud. Go ahead and send me an email at Support@conductivelabs.com and I'll get you taken care of.
Thanks,
Jesse
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)