Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pitch-bend pass through?
#2
(01-14-2019, 02:21 PM)leave trace Wrote: I'm using a Keystep midi out connected to the midi A in on the NDLR, sending note data to a couple synths on the A out. 

From what I can tell, it appears that the NDLR is not passing through / transmitting any pitch-bend data to the connected synths. Is this expected? Is there a setting for this that I have missed?

If it is plugged into the 5-Pin "A" MIDI IN port it should come out the 5-Pin "A" MIDI OUT port + USB 1 MIDI OUT port.  UNLESS it is on The NDLR Control channel (set in Settings 1 menu).   I just verified this too with the Keystep, monitoring the MIDI stream via MIDI OX on my dev PC.

BTW: Starting on Page 29 of The NDLR manual there is MIDI message flow info there.

Also notice that the pitch-bend MIDI Ch can be set in the Arturia MIDI Control Center to "user" or any other Ch... 

Thanks,
Steve
Reply


Messages In This Thread
Pitch-bend pass through? - by leave trace - 01-14-2019, 02:21 PM
RE: Pitch-bend pass through? - by Steve - 01-14-2019, 09:03 PM
RE: Pitch-bend pass through? - by leave trace - 01-16-2019, 04:21 PM
RE: Pitch-bend pass through? - by StuMiller - 03-12-2020, 12:59 PM
RE: Pitch-bend pass through? - by StuMiller - 03-20-2020, 09:20 AM
RE: Pitch-bend pass through? - by StuMiller - 03-20-2020, 10:23 PM
RE: Pitch-bend pass through? - by Hideous mutant - 07-01-2020, 03:03 PM
RE: Pitch-bend pass through? - by Golden_Ratio - 09-03-2020, 05:49 AM
RE: Pitch-bend pass through? - by Mescalina - 09-26-2020, 03:48 PM
RE: Pitch-bend pass through? - by Mescalina - 09-27-2020, 03:22 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)