05-26-2020, 01:33 AM
Hi, I ran into the same problem. Tried installing firmware 1.1.063 using teensy on Mac OSX with a USB connection.
First I got the message in teensy that the hex file was too large and I followed the instructions on the firmware installation webpage, and clicked on the Auto button and then the FW button. It ran for a brief instant and then teensy hung with a line at the bottom that says 79% used.
The NDLR has now gone black and cannot restart (tried the Shift-Menu held down and reboot method but didn't work also). I deleted and re-installed teensy hoping to reload the hex file and re-try but teensy still has the 79% used text at the bottom each time it is opened and after reloading the hex file.
Is there any way I can revive the NDLR? Any advice will be much appreciated by this fragile soul.
Thanks.
First I got the message in teensy that the hex file was too large and I followed the instructions on the firmware installation webpage, and clicked on the Auto button and then the FW button. It ran for a brief instant and then teensy hung with a line at the bottom that says 79% used.
The NDLR has now gone black and cannot restart (tried the Shift-Menu held down and reboot method but didn't work also). I deleted and re-installed teensy hoping to reload the hex file and re-try but teensy still has the 79% used text at the bottom each time it is opened and after reloading the hex file.
Is there any way I can revive the NDLR? Any advice will be much appreciated by this fragile soul.
Thanks.