Pressing the pad encoders does not bring up the pad sub screen

[Jesse Johannesen]

We got this fixed! Follow the link below for the firmware Hex and follow the directions on the Conductive Labs website for updating firmware. If you're updating from 1.1.063 or older, you will need to do a factory reset afterwards which will wipe out any user saves you may have, so write down any critical information beforehand, no need to do so if you're using 1.1.066 or later.

FW available here: https://conductivelabs.com/forum/forumdi...php?fid=10
Thanks for the help tracking this down,
Jesse