08-14-2020, 07:29 PM
Hey, I'm new to the NDLR, but have spent quite a few hours with it already. But try as I might, I can't seem to figure out how to get the LFO to start in phase with the overall chord sequence. It just seems to freely run on its own, so I can't get a reliable result each time I reset the sequence.
Is this normal behavior? I couldn't find any reference to this in the manual.
I thought maybe the 'Pad Qnt' needed to be set. I have an issue with 'Pad Qnt' because when I have it enabled, my pads late/out of sync with the rest. Turning off 'Pad Qnt' fixes that issue...
Is this normal behavior? I couldn't find any reference to this in the manual.
I thought maybe the 'Pad Qnt' needed to be set. I have an issue with 'Pad Qnt' because when I have it enabled, my pads late/out of sync with the rest. Turning off 'Pad Qnt' fixes that issue...