Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[SOLVED] How to take the gate down and up again when the drone changes?
#1
I use the NDLR and some MIDI to CV magic to play a few analog synths. All good. 

My problem starts when I would like to trigger an envelope generator (a Roland 540) every time the drone chord changes. I can't do that, because the gate coming out of the drone is always up... 

... except every few minutes when - I don't know what happens - perhaps some electrical hiccup actually interrupts the gate for an instant and the envelope starts. I like the serendipity but that's not what I wanted :-)

I hoped that the solution was in the trigger / cadence settings of the drone, but so far I had no luck, the gate is always up. Any suggestions? 

For the time being I could solve the problem in an incredibly convoluted way, though fun to describe. The note (aka, the voltage) from the NLDR goes into a quantizer (Expert Sleepers' Disting). The quantizer triggers a trigger when it detects the change of note. The trigger goes then into Make Noise Maths that transforms it into a gate, and that gate finally goes into the envelope generator.

Looking forward to your advice!

G.
Reply


Messages In This Thread
[SOLVED] How to take the gate down and up again when the drone changes? - by giacecco - 11-07-2020, 10:38 AM

Forum Jump:


Users browsing this thread:
2 Guest(s)