Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[SOLVED] How to take the gate down and up again when the drone changes?
#3
Thanks a lot @House de Kris. 

The MIDI to CV magic was taken care of by VCV Rack. I've run a few more experiments tonight following your suggestions and I actually do see the note off / on in Bitwig Studio's oscilloscope instead. 

It is not clear if the problem is VCV Rack, or VCV Rack on my laptop, or the modules (I've tried two, including VCV's default "SCOPE"), but in the meantime I've created an issue on their GitHub.
Reply


Messages In This Thread
RE: How to take the gate down and up again when the drone changes? - by giacecco - 11-09-2020, 12:31 PM

Forum Jump:


Users browsing this thread:
2 Guest(s)