Aligning/syncing parts, sequencer, modulation

[Jesse Johannesen]

At this point there really isn't a reliable way to sync all those elements. I see where it would be beneficial and I hope we can address it at some point, but the next few months are going to be tied up with the MRCC launch. In the mean time I would consider the following: any of the modulations that use a number of seconds as a measure sync arbitrarily. I would stick to modulation in bars if you want things to line up. I forget if those reset with a play message when stopped or not. I think it goes like this if you press play from stopped they start from 0, but pausing a part doesn't reset them unless you stop all. I could be wrong but I think that is the current behavior.
If I have time I'll try to figure out a way to test this and report back.
Jesse