Conductive Labs Support Forum › The NDLR › General Support v
Pattern not saved?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Pattern not saved?
rotur Offline
Junior Noodler
**
Posts: 4
Threads: 1
Joined: Nov 2019
Reputation: 0
0
#2
01-15-2021, 02:41 PM (This post was last modified: 01-15-2021, 03:01 PM by rotur.)
Just as a follow up, the NDLR reboots into a default state and I go to Shift + Menu + Enc 5 and scroll Enc 1 to the previously saved position (21) then press Shift + Enc 1 to load...but I don't get the green Loaded confirmation message on the screen. Do I have a faulty unit?
OK have just discovered the Global Load/Save settings so all is good now...
Find
Reply


Messages In This Thread
Pattern not saved? - by rotur - 01-15-2021, 05:45 AM
RE: Pattern not saved? - by rotur - 01-15-2021, 02:41 PM
RE: Pattern not saved? - by Jesse Johannesen - 01-17-2021, 07:51 AM
RE: Pattern not saved? - by rotur - 01-22-2021, 09:24 PM
RE: Pattern not saved? - by Jesse Johannesen - 01-22-2021, 10:32 PM

Forum Jump:


Users browsing this thread:
2 Guest(s)