02-05-2021, 12:18 PM
Hi Flavio,
I measure using a rigol oscilloscope.
I use a multiclock to achieve the tight timing by offsetting the clock pulses until all my sequencers are as close to in phase as the multiclock will allow.
The issue is not with the cables of course. The issue is with the system, not just with the device at the end.
It should compensate all the time. If it introduces 1.4ms, offset 1.4.
I already explained that it waits four pulses to send the negatively offset ones.
I measure using a rigol oscilloscope.
I use a multiclock to achieve the tight timing by offsetting the clock pulses until all my sequencers are as close to in phase as the multiclock will allow.
The issue is not with the cables of course. The issue is with the system, not just with the device at the end.
It should compensate all the time. If it introduces 1.4ms, offset 1.4.
I already explained that it waits four pulses to send the negatively offset ones.