Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Clock IN from Volca Sync
#6
(03-26-2021, 04:55 PM)gopilot Wrote:
(03-26-2021, 03:43 PM)House de Kris Wrote: They kinda hint at the possibility of PPQs other than 24 in the manual as a future enhancement, but I wouldn't hold my breath. Otherwise, could you use the NDLR as the clock master and sync the Volca to that? This would be using the MIDI connection between the two.

You are correct on the MIDI connections. But, what I'm trying to do is use the volca Drum as the master Clock -> running into the NDLR which is synced via a MIDI hub to four other volcas.  I like using a drum machine as my Master Clock and since I don't control the Drum from the NDLR I'd rather not have it hooked up via MIDI but alas, if I want them sync'd I must.

While it is possible to run the NDLR as a secondary device to another master device, I usually recommend against it as when the clock stops, it tends to leave notes hanging. If at all possible I would figure out an alternate method, as the current firmware has the PPQN issue with the volcas already. It should be possible to use the Analog clock out from one of the MIDI synced volcas to drive the V. Drum maybe?

Jesse
Reply


Messages In This Thread
Clock IN from Volca Sync - by gopilot - 03-19-2021, 12:50 PM
RE: Clock IN from Volca Sync - by House de Kris - 03-26-2021, 11:03 AM
RE: Clock IN from Volca Sync - by gopilot - 03-26-2021, 12:14 PM
RE: Clock IN from Volca Sync - by House de Kris - 03-26-2021, 03:43 PM
RE: Clock IN from Volca Sync - by gopilot - 03-26-2021, 04:55 PM
RE: Clock IN from Volca Sync - by Jesse Johannesen - 03-27-2021, 04:17 PM
RE: Clock IN from Volca Sync - by gopilot - 03-29-2021, 05:21 PM
RE: Clock IN from Volca Sync - by tkrhen - 04-14-2021, 02:35 AM
RE: Clock IN from Volca Sync - by gopilot - 04-20-2021, 07:06 PM
RE: Clock IN from Volca Sync - by gopilot - 04-23-2021, 09:09 AM

Forum Jump:


Users browsing this thread:
3 Guest(s)