06-23-2021, 06:31 AM
On the routing config page; tab to the input port, turn encoder lights cycle to the input port selected - that works. However, if I tab to the output port I cannot cycle through ports with the encoder.
On another note; the encoder has the same issue as the NDLR had; Sometimes a notch turn does nothing and you have to dial another notch in to get what you wanted. This isn't as big a deal as it was on the NDLR but it's still a little annoying and surprising to see the same issue on another product.
On another note; the encoder has the same issue as the NDLR had; Sometimes a notch turn does nothing and you have to dial another notch in to get what you wanted. This isn't as big a deal as it was on the NDLR but it's still a little annoying and surprising to see the same issue on another product.