06-23-2021, 07:04 AM
Hey,
The Sysex routing bug appears to be on all routings, but only in the specific scenario where you Midi Map to the 4 channels and block all others (exclusive mode). It should be an easy fix, but isn't port dependent.
The C-P1 mod should work like this:
If I route port 3 to port 5 and place the C-P1 mod in the routing, then channel 5 of Port 3 will output at channel 1 of port 5. It's useful if you have each device set to a different port so that you can easily route to the correct device without needing many many channel map mod configurations (since there are only 6 available). This way you can set each device to channel 1 and plug them in and reliably route a single source to any of them without much complication.
So basically this, but the output channel is 1 instead of the port number.
Jesse
The Sysex routing bug appears to be on all routings, but only in the specific scenario where you Midi Map to the 4 channels and block all others (exclusive mode). It should be an easy fix, but isn't port dependent.
The C-P1 mod should work like this:
If I route port 3 to port 5 and place the C-P1 mod in the routing, then channel 5 of Port 3 will output at channel 1 of port 5. It's useful if you have each device set to a different port so that you can easily route to the correct device without needing many many channel map mod configurations (since there are only 6 available). This way you can set each device to channel 1 and plug them in and reliably route a single source to any of them without much complication.
(06-23-2021, 02:24 AM)oldgearguy Wrote: So if you had 4 synths on ports 1-4 and each synth was set to receive on a single MIDI channel (channel happens to equal their assigned port number), then a multi-track sequence coming in port 5 can be routed to each synth so that each synth only sees the track data assigned to it on its assigned MIDI channel.
So basically this, but the output channel is 1 instead of the port number.
(06-23-2021, 02:24 AM)oldgearguy Wrote: Does the C-P1 setting filter clock/realtime or anything else or does it just filter any/all data that is channel based?It shouldn't block clock as far as I know, but it hasn't been tested by the beta team so this may need some further experimentation to confirm. If it does, let me know and I'll make a bug report and get it sorted.
Jesse