08-04-2021, 06:35 PM
This is a cool tip, I'll be getting one of these splitters to go with the second MRCC I just ordered. Couple of questions:
The verbiage you've used here and elsewhere about cable specs, specifically shielded connectors, is often absent in descriptions on store pages, even if shielded cables are specified. Is there a minimum cable type that will always meet the requirement, say Cat6 or Cat6a or something else? I have one of these that I was hoping to use between the two MRCCs: https://www.bhphotovideo.com/c/product/1...gless.html
With 2 MRCCs working in tandem, will both need to be connected via USB to the computer for a) firmware updates, and / or b) routing to a DAW?
Do the 6 pins on the splitter being trimmed as short as possible pose any kind of shorting potential, or are the contacts in the cable connector far forward enough to preclude a likely short?
Thanks!
The verbiage you've used here and elsewhere about cable specs, specifically shielded connectors, is often absent in descriptions on store pages, even if shielded cables are specified. Is there a minimum cable type that will always meet the requirement, say Cat6 or Cat6a or something else? I have one of these that I was hoping to use between the two MRCCs: https://www.bhphotovideo.com/c/product/1...gless.html
With 2 MRCCs working in tandem, will both need to be connected via USB to the computer for a) firmware updates, and / or b) routing to a DAW?
Do the 6 pins on the splitter being trimmed as short as possible pose any kind of shorting potential, or are the contacts in the cable connector far forward enough to preclude a likely short?
Thanks!