08-07-2021, 06:12 PM
(This post was last modified: 08-07-2021, 06:13 PM by Nelson Baboon.)
I'm currently a bit lost, and trying to set up some more complex routings.
I have 2 mrccs connected. Let's call them mrcc1 and mrcc2.
The second one is next to a squarp pyramid sequencer. I have plugged the usb port from the pyramid into the usb port 1 on mrcc2.
Now, one of the things that I'm not sure about is the directionality of this connection between the mrccs. Obviously, the ethernet cable itself doesn't establish a master/slave relationship, so I'm a bit confused. Up until now, i've been assuming that I had to set up the routings on mrcc1 so that I could send data to either mrcc. But if there is no direction to the connection, that wouldn't matter?
Where should I set up this routing, and how exactly would I do it? Say, if I wanted to record from a keyboard into the pyramid? (the keyboard is right by the second mrcc also). So, if I plug the midi out of the keyboard into the the din input one of mrcc2, i should be able to route these like any other in/out connections? But if I wanted to connect to this keyboard from a midi controller near the other mrcc - how exactly would I do this?
If I figure this all out tonight I will post. I guess the idea is to set this up step by step and test whether it's working at each step.
I have 2 mrccs connected. Let's call them mrcc1 and mrcc2.
The second one is next to a squarp pyramid sequencer. I have plugged the usb port from the pyramid into the usb port 1 on mrcc2.
Now, one of the things that I'm not sure about is the directionality of this connection between the mrccs. Obviously, the ethernet cable itself doesn't establish a master/slave relationship, so I'm a bit confused. Up until now, i've been assuming that I had to set up the routings on mrcc1 so that I could send data to either mrcc. But if there is no direction to the connection, that wouldn't matter?
Where should I set up this routing, and how exactly would I do it? Say, if I wanted to record from a keyboard into the pyramid? (the keyboard is right by the second mrcc also). So, if I plug the midi out of the keyboard into the the din input one of mrcc2, i should be able to route these like any other in/out connections? But if I wanted to connect to this keyboard from a midi controller near the other mrcc - how exactly would I do this?
If I figure this all out tonight I will post. I guess the idea is to set this up step by step and test whether it's working at each step.