Hi guys. I have a digitakt connected to the NDLR in - but the only mapped CC is for the chord changes and it's not sequenced/sending anything right now (I had it sequencing chord changes yesterday and all was working fine). I have the default settings for the control and keyboard channels (and most other settings). I am sending start/stop to the digitakt via the MIDIB on the NDLR - would this cause a 'loop' (thinking now I assume it can't as I'm using MIDIA for the tracks, all MIDIB should be outputting from NDLR is transport right?)? I'm not sure how this could be avoided.
I was fiddling with the pattern editor so that's probably the issue with that motif! Thanks for the tip, I hadn't even noticed that setting so could well have changed something by mistake.
Setting up the midi configuration has been a bit of challenge - but I have successful sessions and then get plagued with these bugs so whatever it is it's not consistent.
Right now my my Subharmonicon is reacting to every track sent from the NDLR (but only on a specific save), even after restarting the sub, and even though the sub is fixed to a specific MIDI channel. If I send MIDI data from my digitakt to Subharmonicon then it will only play on the right channel. So seems very much like NDLR is sending all track data out on that midi channel.... for some reason.
I was fiddling with the pattern editor so that's probably the issue with that motif! Thanks for the tip, I hadn't even noticed that setting so could well have changed something by mistake.
Setting up the midi configuration has been a bit of challenge - but I have successful sessions and then get plagued with these bugs so whatever it is it's not consistent.
Right now my my Subharmonicon is reacting to every track sent from the NDLR (but only on a specific save), even after restarting the sub, and even though the sub is fixed to a specific MIDI channel. If I send MIDI data from my digitakt to Subharmonicon then it will only play on the right channel. So seems very much like NDLR is sending all track data out on that midi channel.... for some reason.