10-21-2021, 09:47 AM
Yes Tom is correct, currently the only way to send clock from Logic to other ports is to create a routing for each port from the PC port connected to Logic. If you only want to send clock you'll then need to add filters for CCs, Notes, etc. for each routing.
To send clock via the MRCC as master you need to go to the clock page and select all ports to send to (press port buttons and they will light red). You then need to enable the clock and select whether to send clock tics while it's stopped or not (clock tick on stop?), and lastly (and this one is always confusing to me so bare with me) the last option is whether or not to send Start Stop Continue messages when you press those transport buttons on the MRCC screen, to ports which have filters blocking those messages. I always get the wording backwards when I look at it so I believe a no here means "Yes send the messages anyway" and a yes means "yes, respect the rule already in place and block the messages. I will take a closer look at the manual and edit this post if that is backwards, it's just been a while since I looked at it.
Now if all that is set up you should be able to select "Start" at the top of the menu and start the internal clock, and if you update to the newest FW, it will automatically send the cursor over to select stop and toggle those back and forth so you dont need to monkey with the selection screen to move back and forth between those to do those actions. (ie: if you highlight start and press the enter button, the next time you press enter will stop the clock.)
The only way to send clock to the analog clock out currently is via the internal MRCC clock.
Jesse
To send clock via the MRCC as master you need to go to the clock page and select all ports to send to (press port buttons and they will light red). You then need to enable the clock and select whether to send clock tics while it's stopped or not (clock tick on stop?), and lastly (and this one is always confusing to me so bare with me) the last option is whether or not to send Start Stop Continue messages when you press those transport buttons on the MRCC screen, to ports which have filters blocking those messages. I always get the wording backwards when I look at it so I believe a no here means "Yes send the messages anyway" and a yes means "yes, respect the rule already in place and block the messages. I will take a closer look at the manual and edit this post if that is backwards, it's just been a while since I looked at it.
Now if all that is set up you should be able to select "Start" at the top of the menu and start the internal clock, and if you update to the newest FW, it will automatically send the cursor over to select stop and toggle those back and forth so you dont need to monkey with the selection screen to move back and forth between those to do those actions. (ie: if you highlight start and press the enter button, the next time you press enter will stop the clock.)
The only way to send clock to the analog clock out currently is via the internal MRCC clock.
Jesse