Assign labels

[Jesse Johannesen]

Interesting. So if you assign labels but don’t save the preset, the port labels will revert to their previous values if the device is power cycled?

I can understand the desire to optimize the assign label workflow, but a selected label should not override the value of previously assigned port labels. As a software developer, I find this very unintuitive. Another example: you assign a label to A1 In and the same label looks like it’s assigned to A2-4 In — except it isn’t. There’s no way to actually see with any confidence which labels are assigned to which ports without going to the routes page.

It's more like this: 
All labels are temporary and in volatile memory. 
If you save a preset the Labels are part of the preset.
When you power cycle, it just loads the last saved preset, so any labels that exist in that preset now exist in the current state of the unit.