PC getting filtered even when no filters are on

[matthew]

I am running into an odd issue with the Hapax and the MRCC. I am sending Program Changes via the Hapax, and the MRCC registers them (On the routing page I can see that its getting them on the right channel), however it never makes it to the device its sending it to. If I connect the hapax directly to the device the PC's get through just fine, but as soon as I drop the MRCC in the chain, nothing. It really feels like a filtering issue, but I have no filters set, and I am using the factory settings.

Any pointers?

What ports are you using for the MRCC connections?  USB or DIN?
I had a weird situation where I thought Program Change messages weren't getting through but I never took the time to pin down exactly what combination was causing it.
It could also have been something else causing what i was seeing, so I haven't reported it yet.

Both are DIN (DIN 1 input -> DIN 1 output). I haven't had much luck with my USB adventures with the MRCC. Ill grab video of it today as its super easy to see what is going on.