(04-08-2022, 08:10 AM)oldgearguy Wrote:(04-08-2022, 05:48 AM)Stratblue Wrote: So....I've updated to the 52 firmware and can see it in the start up screen however I'm still getting nothing. I'm going from PC out1 to din output 1, where my Octopus sequencer resides, and din output 6 where I have a midi indicator. The file I'm sending is in Sysex librarian and it's sending on Port 1, I've posted the sysex file below. I see a little green arrow in the display during transmission and the midi indicator flashes but the Octopus refuses to acknowledge receipt. Any help would be great.
Since the sysex file is large, you'll have to configure Sysex Librarian to send smaller (less than 512 byte) buffers of data with a slight pause between transmissions and possibly slow down the overall transmission rate. Not in front of the Mac at the moment, but if no one has some screen shots/numbers later today, I'll post some suggestions.
Hey OGG.
I was looking in Sysex Librarian and I don't see anywhere to adjust the size of the sysex, I do see pause between played messages, a receive timeout and transmission speeds though.