05-10-2022, 09:05 PM
Hey Nelson, can you give me a quick outline of the signal flow you are attempting to route here? Is the source the PC in Port 3 and destination PC out Port 1?
So to route that you would press and hold the left hand PC button and while held press Port 3, then Press and hold the right hand PC button and while held press the Port 1 button for instance. Once routed the Routing page should show symbols for MIDI data being passed, and if that is the only thing being routed, you could go over to the MIDI monitor at the end of the Tools menu, and that should show all data being passed, (which would only be this port since that is all that is routed). You may need to enable the monitor by navigating to the play pause tab stop and pressing the selection button.
If all that fails please feel free to send me an email at support@conductivelabs.com and I will set up a zoom meeting to take a look.
Jesse
So to route that you would press and hold the left hand PC button and while held press Port 3, then Press and hold the right hand PC button and while held press the Port 1 button for instance. Once routed the Routing page should show symbols for MIDI data being passed, and if that is the only thing being routed, you could go over to the MIDI monitor at the end of the Tools menu, and that should show all data being passed, (which would only be this port since that is all that is routed). You may need to enable the monitor by navigating to the play pause tab stop and pressing the selection button.
If all that fails please feel free to send me an email at support@conductivelabs.com and I will set up a zoom meeting to take a look.
Jesse