08-05-2022, 12:39 PM
(This post was last modified: 08-05-2022, 12:39 PM by oldgearguy.)
You're definitely doing the first half correctly.
Assign an output to a port in Bitwig (port 8 like you said).
Hold the left button under the PC port on the MRCC and select port 8 (like you said).
What you've done to this point is said -- send MIDI to port 8 of the MRCC.
What I didn't see you typing was now assigning that PC port to some destination synth.
The left PC port button should be lit up. Press an output port on the MRCC to route the PC port to that synth.
If done correctly, there should be the PC port left button lit up and some port in the 1-12 output section lit up.
The actual MIDI channel does matter as well. Each connection you just made can carry 16 MIDI channels. So inside Bitwig, set the source/track to some MIDI channel. Make sure the synth is set to the same thing and it should all just work at that point.
Assign an output to a port in Bitwig (port 8 like you said).
Hold the left button under the PC port on the MRCC and select port 8 (like you said).
What you've done to this point is said -- send MIDI to port 8 of the MRCC.
What I didn't see you typing was now assigning that PC port to some destination synth.
The left PC port button should be lit up. Press an output port on the MRCC to route the PC port to that synth.
If done correctly, there should be the PC port left button lit up and some port in the 1-12 output section lit up.
The actual MIDI channel does matter as well. Each connection you just made can carry 16 MIDI channels. So inside Bitwig, set the source/track to some MIDI channel. Make sure the synth is set to the same thing and it should all just work at that point.