Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MRCC used through a USB hub?
#4
(10-14-2022, 08:45 PM)toddk Wrote:
(10-14-2022, 08:23 PM)Dark Waves Wrote: A USB hub is not a problem.  I have 2 MRCCs plugged into two different TP-Link hubs, then to a PC.  You should be aware that there is not any kind of remote control of the MRCC from other devices (computers, etc.) as all physical routing is done on the front panel (there are a number of threads touching on this subject).  However, there will be port assignments made in your software, since there are 24 virtual MIDI connections (12 in each direction) between MRCC and computer over the single USB connection, and you'll need to assign which ones match with which devices your DAW, for example, needs as connections., which can be from 1 to 24 depending on your requirements,   Having a quality hub in between has not affected the performance in my setup.

Thanks so much! This is obviously welcome news. I am aware I'll need to use the front panel to do routing which is fine with me. Excited for this to show up!

Did the device arrive? if so, how has your experience been with the iPad? iPad is a big part of my set up alongside some hardware I have. Trying to do my research before making this investment. Thank you.
Reply


Messages In This Thread
MRCC used through a USB hub? - by toddk - 10-14-2022, 06:57 PM
RE: MRCC used through a USB hub? - by Dark Waves - 10-14-2022, 08:23 PM
RE: MRCC used through a USB hub? - by toddk - 10-14-2022, 08:45 PM
RE: MRCC used through a USB hub? - by krazywabbit - 11-09-2022, 04:51 PM
RE: MRCC used through a USB hub? - by toddk - 11-09-2022, 07:19 PM
RE: MRCC used through a USB hub? - by krazywabbit - 11-09-2022, 07:35 PM

Forum Jump:


Users browsing this thread:
3 Guest(s)