Shift Five Rabbit Hole
03-26-2023, 11:51 AM
Stepped on a bit of a land mine while learning the NDLR interface ... (I'm using the encoder numbering from the Quick Start Guide):
... gives me:
("Shift + Menu MENU 5: Under Construction!")
No problem ... except ...
Once I do this, I seem to be "stuck" in Shift Mode somehow. Whenever I go back to the Rhythm Editor, even after exiting and doing other stuff, and even when I click encoder #8 without holding Shift, I get the same "Shift + Menu ..." message as shown above. Shift seems to be "stuck" on ...
Maybe there IS nothing on the unshifted encoder 5, and it just happens to be showing the same "Shift + Menu ..." message?
I'm on firmware v1.1.079. Any assistance appreciated ...
- Shift + Menu
- Pattern Editor (press encoder #6)
- Menu 5 (press encoder #8)
... gives me:
("Shift + Menu MENU 5: Under Construction!")
No problem ... except ...
Once I do this, I seem to be "stuck" in Shift Mode somehow. Whenever I go back to the Rhythm Editor, even after exiting and doing other stuff, and even when I click encoder #8 without holding Shift, I get the same "Shift + Menu ..." message as shown above. Shift seems to be "stuck" on ...
Maybe there IS nothing on the unshifted encoder 5, and it just happens to be showing the same "Shift + Menu ..." message?
I'm on firmware v1.1.079. Any assistance appreciated ...