Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LFO on Pad Position: Chrods drop out
#2
I haven't run into that exact same scenario, but kinda similar. I'm using 1.1.079. What I've run into is the Pad dropping out completely when I change Pad Range via CC#. It happens only rarely, but when it does it is annoying. I use a constrained random number generator on another device that sends CC#s, and sometimes, when the number is low, it just seems to drop to 0 instead of what was sent.

I use the internal LFO to Pad Position a lot, and have never had the Pad drop out completely. What are the specifics of your situation?

1. Internal LFO (or MOD) or external LFO sending CC#s?
2. LFO waveshape?
3. LFO rate?
4. Modulation %?
5. Dest Value?

I can't say that that information will help me help you. But, it may help others at CL to recreate your situation.
Reply


Messages In This Thread
RE: LFO on Pad Position: Chrods drop out - by House de Kris - 08-12-2023, 06:14 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)