Do you need this MRCC accessory?

[Jesse Johannesen]

I wish the Expander was over the RJ45 port so that I can get some input/output further away from the MRCC

We made it possible to connect 2 MRCCs via this port, here is the relevant info from page 49 of the manual:

MRCC-to-MRCC “remote” connection
Two MRCCs can connect to each other via the RJ45 cable. When 2 MRCCs are connected they will auto
detect each other and the “=Y” icon in the upper right corner of the screen will illuminate.

The MRCC-to-MRCC connection extends the number of out-ports by 12x 5-pin + 4x USB Host + 1 USB
device ports on the connected MRCC. In order to route MIDI messages to an extended out-port press
and hold the “Y” button, then select the desired out-port. This mode works the same way routing MRCC
out-ports but with Yellow LEDs (not blue). 

Press and hold the “Y” button while on the Activity screenand it will say “REMOTE” and show all the
remote routings in yellow. Press and hold the “Y” button while on the Routing screen and it you will 
see that the out-port names are prefixed with an “r” i.e. “1 -> r4”

I know that's in a higher price-point from the 4x1, but the possibility exists if you need it.