MIDI not passing through outputs
08-18-2024, 10:43 AM
(This post was last modified: 08-18-2024, 10:45 AM by berth.
Edit Reason: Clarity and formatting
)
I have an update here: When I run the Summit MIDI out directly into the Tracker+, notes get through fine and I can hear the individual synths played when I have their respective tracks selected in the Tracker+, but ONLY via channel 1 out from the 880.
None of the other synths are receiving MIDI notes that I can see. If I swap out the 1 and 2 outputs, then the Hydrasynth receives its respective MIDI notes sent to MIDI channel 2 and plays.
So, it would seem the outputs on the 880's channels 2-4 are not sending data (yes, I have ensured that when channel 1 in is selected, 1-4 on the outputs are also selected).
I have also tried a couple different power supplies—both usb phone power and >= 1a. I don't want to assume I am not doing something wrong or misunderstanding the 880's capabilities, but at this point I have read the manual a few times, tested different configurations, and it seems like I might have a defective unit? Please correct me if I a wrong. Thanks!
None of the other synths are receiving MIDI notes that I can see. If I swap out the 1 and 2 outputs, then the Hydrasynth receives its respective MIDI notes sent to MIDI channel 2 and plays.
So, it would seem the outputs on the 880's channels 2-4 are not sending data (yes, I have ensured that when channel 1 in is selected, 1-4 on the outputs are also selected).
I have also tried a couple different power supplies—both usb phone power and >= 1a. I don't want to assume I am not doing something wrong or misunderstanding the 880's capabilities, but at this point I have read the manual a few times, tested different configurations, and it seems like I might have a defective unit? Please correct me if I a wrong. Thanks!