MRCC Firmware Release 1.1.095

[Darryl]

There is no other issue, I have verified other possible causes. 

I wasn't aware there is additional "monitor" on the routing screen! 

I can see the that switching group on Faderfox actually produces some output. 

Here is the message: 

0 > sX



After that, the matrix and routing monitors continue to act normally, but the monitor tool + the actual connected devices don't indicate any further messages occurring.

---

I will catch the SYSEX message on the computer and pay it here. 

TBD

Also I should note, that it was working alright in the previous beta, so it most likely has something to do with the sysex adjustments in the most recent beta.

If possible, it would be helpful if you can capture the output of your controller so we can try sending all of the MIDI data to test it. Not just the SysEx, but the whole list of commands. I'm wondering if there's a problem caused by switching presets, which can take a little time to load. Is there any delay between the Program Change and SysEx output?