USB sysex issues

[Stratblue]

Wow, not sure where the problem could lie, that seems like it shouldn't be any issue. It's not even a full packet of data. The locking up is usually an indication of a MIDI loop, but without a thorough picture of the routing it's not easy to guess what could be the likely issue. Maybe we need to set up a Zoom call to get into this deeper? Email me at support@conductivelabs.com with some timezone info and your likely availability and we can pin down a time.

Is the Octopus project you mention software? I googled it and I'm getting a band from TX.

I don't think there is a loop. Electra One > MRCC1 > MRCC 4 > V Synth. I checked everything else. This isn't from a save, this is the factory patch and I have made sure the MRCC1 > MRCC1 that is contained in that patch is off.

It behaves ok until I send some sysex and then it just clogs up, the incoming program changes don't even wake the screen from sleep. If take the lead from MRCC in 1 and plug into MRCC in 2 it all works just fine.

I've erased all (GULP!) my patches, done a factory reset and re installed the 73 firmware. It seems like this is just a repeat of the problem you may remember I had a few months ago where port 2 just decided to quit on me. Sent it away, they said it worked and sent it back with a £100 bill and indeed it worked perfectly. You saw the video IIRC.

The Octopus is a Genoqs Octopus sequencer.

I'll email now and set something up with you on zoom.

Thanks.