Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Remote 7 stopped working
#1
Hello... just powered up my studio and found the devices connected to the Remote 7 weren't triggered via MIDI. Tried another ethernet cable but no luck. Remote 7 is enabled and no change if set to Remote 1-5 or Copy 1-5. With a hardware MIDI tester connected to MIDI Out 1 on the MRCC I am seeing data pass but not if I then move that tester to output 1 of the Remote. FWIW, I'm on 1.1.071 though it was working fine so not sure that matters.

Any thoughts?  Thanks.
Reply


Forum Jump:


Users browsing this thread:
2 Guest(s)