+- Conductive Labs Support Forum (https://conductivelabs.com/forum)
+-- Forum: MRCC - MIDI Router Control Center (https://conductivelabs.com/forum/forumdisplay.php?fid=13)
+--- Forum: General Support (https://conductivelabs.com/forum/forumdisplay.php?fid=14)
+--- Thread: Changing MRCC presets through incoming program change messages (/showthread.php?tid=1425)
Changing MRCC presets through incoming program change messages - chrisharrisx - 03-11-2021
Hello all, just discovered the MRCC and it looks like it will be a very useful addition to my current setup. Looking through the draft manual I see that there are presets that are saved to the SD card, but I didn't see any info on whether it's possible to switch presets via incoming MIDI.
A basic use-case I'm imagining is a sequence coming in on one port, routed to a couple of synths via two output ports, then being able to change the input to output mapping (i.e. to two other synths) rhythmically using something like a program change message...
RE: Changing MRCC presets through incoming program change messages - Darryl - 03-22-2021
Selecting Presents via CC or Program Change is on the to-do list.
RE: Changing MRCC presets through incoming program change messages - chrisharrisx - 03-22-2021
(03-22-2021, 04:11 PM)Darryl Wrote: Selecting Presents via CC or Program Change is on the to-do list.
Good to hear, thanks for letting me know!
RE: Changing MRCC presets through incoming program change messages - WinterEdge - 03-28-2021
Will it be possible to convert an incoming note or CC from one device to a program change on another?
RE: Changing MRCC presets through incoming program change messages - Jesse Johannesen - 03-29-2021
(03-28-2021, 12:45 PM)WinterEdge Wrote: Will it be possible to convert an incoming note or CC from one device to a program change on another?
That is not one of the scenarios that have been discussed with me at this point, so I would guess no, however I don't see anything that wouldn't be doable about it. Just a matter of conveying the benefits of implementing it to Steve and convincing him to agree with you.
I'll add this to the feature requests.
Jesse